We can handle all project big or small.
Below are just some examples of our work. Want to see more? Give us a call or contact us and we'll set-up an appointment with you.
P.O. Box 443
Greenville, RI 02828
This oil to gas conversion required us to remove the oil tank, boiler and water heater. We also removed all the old steam lines that had been converted to hot water. Once removed we were able to add a zone of heat for the second floor, which allows a much more comfortable heating system. We then constructed a wall for the boiler to be installed. This heating system should save the homeowners approximately 30% annually on their heating bills.
This is a newly renovated bathroom. The shower is made up of Grohe valves with a standard shower head, a hand held shower on a slide bar and body spray system with 3 body sprays. All the shower heads are capable of being run at the same time or individually. This bathroom also has hot water in floor radiant heating, making it truly a Master Getaway!
Prestige SOLO with Indirect Water Heater
We were brought into a home that had an existing oil boiler. The boiler had been converted to natural gas via a conversion burner. After we did a heat loss calculation, it was determined that the boiler was grossly over sized. The owner opted for a new Prestige Solo high efficiency boiler and, due to the bathrooms in the home, a 60 gallon indirect water heater. This project required some major pipe reconfiguration. Under normal circumstances, this project would take about 2-3 days.
New Construction Heating
This was a complete installation of plumbing and heating. We installed a multiple zone hot water baseboard system with an indirect water heater. This project required the boiler to be installed on the 1st floor (the actual 2nd level) of the home and in the laundry room.
New Construction Plumbing
This project is part of a new construction plumbing and heating project. The owner purchased thier own fixtures and we did all the water and drain piping necessary. The shower system is a Grohe with single control. The whirlpool tub is a MAAX with air jets, led lighting and backrest heater. Truly an escape from everyday stress!
Residential Heating Upgrade
Removed existing hot water boiler and wood boiler as well as installed a high efficiency Buderus hot water boiler with a Riello oil burner. We also installed a Rinnai on demand water heater. The time frame for this project was approximately two days.
Commercial Heating Renovation
This project required the replacement of two (2) 750,000 BTU oil fired boilers and a separate 200,000 BTU boiler for domestic hot water. After calculating the heat loss for the building, it was determined that existing system was oversized. We removed the existing boiler and installed two (2) Buderus G515/7 oil fired boilers. All the near boiler piping and circulator pumps were replaced. We installed a flat plate heat exchanger to the existing storage tank and installed a new Holby mixing valve for the domestic hot water. The new system is stage firing with outdoor reset setting the water temperature to the building.
We were asked to design a new bathroom in an existing home. Some of the challenges presented where the fact that the home is very solidly constructed with one inch mortar and wire mesh on the walls. We were also asked to design a shower that could eventually be used with a wheel chair, if needed. We designed a shower with a very small threshold to get in and installed a bench seat. The shower has 3 body sprays, a hand held shower with a slide bar, a main shower head and steam unit. The roof of the shower is curved so as to not let water bead on the surface and drip during the steam unit usage. Another great feature of this bathroom is the radiant heating system. We designed and installed hydronic (hot water) radiant heating under the floor tile, into the shower system and also in the bench of the shower.
Contact Us Anytime
P.O. Box 443 Greenville, RI 02828
(401) 349-3422 info@CallPinnacle.com
© 2015 All rights reserved. Pinnacle Plumbing